Skip to main content
Postmark is one of the email gateways Partnero can send your program’s emails through. Connecting a Postmark server lets those emails go out from your own address, such as [email protected], instead of the default @partnero.email address.
This is about sending email, not syncing data. Postmark does not receive your partners or customers. For that, see Mailchimp or MailerLite.

​
Before you start

You need:
  • The Server API token of the Postmark server you want to send from. Account API tokens can’t send emails. See Postmark’s guide to API tokens.
  • A From email address that is a confirmed sender signature, or that belongs to a verified domain, in Postmark.

​
Connect Postmark

  1. In your program, go to Emails under Affiliate.
  2. On the Settings tab, click Setup next to Use Postmark.
  3. Paste your Postmark Server API token.
  4. Enter your From email address.
  5. Click Connect.
Once connected, Postmark shows a green checkmark and the address it sends as, for example Sending as [email protected].

​
Your sender email

Postmark sends from one address, so connecting it also sets your program’s Sender email to the From address you entered. You don’t need to pick it yourself. The address can’t be edited under Sender email. To send from a different address, disconnect Postmark and connect it again with the new From address.
Click Send test email below the email gateways to confirm everything works before your partners start receiving emails.

​
Disconnecting

Click Disconnect next to Use Postmark and confirm. Your Server API token and From address are removed from Partnero. If Postmark was sending your program’s emails, your sender email switches back to Partnero’s default @partnero.email address, so your emails keep going out.

​
Troubleshooting

Make sure you copied the Server API token from your server’s API Tokens tab, not an Account API token. Also check that the From email address is a valid email address.
Postmark only checks the From address when an email is sent, so connecting can succeed while sending fails. Add and confirm the address as a sender signature, or verify its domain, in Postmark. Then send a test email again.
While your Postmark account is pending approval, Postmark only delivers to addresses on the same domain as your From address. Send the test to an address on that domain, or request account approval in Postmark.

​
Next steps

Email settings

Sender name, reply-to address and email styling

Program emails

Which emails Partnero sends